Table of Contents
Advertisement
IntelliVue Information Center Demo Mode Software Installation
IntelliVue Information Center Demo Mode Software Installation
F-2
Demo Mode Installation Procedure
After the operating system has been installed, verify the Host Name is set to
Demo. Then, the IntelliVue Information Center Application Software can be
installed which contains the Demo Mode program. Install the Application
Software on a PC workstation following procedures given in the "Software
Re-Installation Procedure" on page 7-147
When the SDN Simulator (DemoModeSim) window appears (see below) click
on the Yes button to install the Application Software and Demo Mode
simulator files, and also create the Run Demo icon.
Then, the Configuration Wizard will run. When the Archive Restore
screen appears, browse to the following archive file to restore the factory
default demo mode settings from the hard drive. Note: if no floppy disk is
inserted an ERROR message appears - press Cancel to proceed.
Open the screen and browse to the D: directory to find:
D:\Stardate\BedSim\configs\Archive\Demo16pt.arc
Advertisement
Table of Contents
Troubleshooting
