Table of Contents
Advertisement
Step 2. Press the keyboard F10 key when <F10 = Setup> appears in the lower right of the
screen during the first few seconds of boot up when the word COMPAQ appears on
the screen. The Language Menu displays.
Language
Step 3. Select English in the Language Menu and press Enter to display the Setup
Utility window.
File Menu
Step 4. Select File in the upper row menu bar to display its menu.
Step 5. Select Set Defaults and Exit in the File Menu and press Enter.
When the prompt Are you sure ... appears:
Step 6. Press the keyboard F10 key for Yes. The PC will then automatically reboot.
Step 7. Repeat Steps 1, 2, and 3 to display the File menu again.
Step 8. Select Set Time and Date in the File menu and press Enter to display the
Set Time and Date window.
Step 9. Set the Time and Date in the File Menu following the instructions given on
the screen.
When the prompt Are you sure ... appears:
Step 10. Press the F10 key to Accept. The system returns to the Setup Utility
window.
Storage Menu
Step 11. Select Storage in the upper row menu to display the Storage menu.
Step 12. Select Device Configuration and press Enter to display its menu.
Step 13. Select Hard Disk and IDE Primary 0 and press Enter to display its menu.
Step 14. Select Default Values and IDE Defaults and press Enter to display its
menu. Select Translation Mode, change its value to LBA Assisted using the
keyboard left or right arrow key, and press the F10 key to Accept this change.
Step 15. Press the Esc key to return to the Setup Utility window.
Security Menu
Step 16. Select Security in the upper row menu to display the Security menu.
Step 17. Select Network Service Boot and press Enter to display its menu.
Step 18. Select Network Service Boot and change its value to Disable.
Step 19. Press F10 to Accept these changes and return to the Setup Utility window.
Power Menu
Step 20. Select Power in the upper row menu to display the Power menu.
Step 21. Select Energy Saver and press Enter to display its menu.
Step 22. Select Energy Saver Mode, change its value to Disable, and press F10 to
Accept this change.
Maintenance, Troubleshooting, and Repair
Troubleshooting
7-129
Advertisement
Table of Contents
Troubleshooting
