Philips M3150B Installation And Service Manual page 330

Troubleshooting
The Details: field displays the following information.
Notes The column width of the Details field can be changed by clicking and holding on the vertical
line separating the field titles and moving the line left or right.
Arrows in the corners of the field scroll the field left/right and up/down.
The Status Log can only be accessed from Monitoring Mode.
7-44
Maintenance, Troubleshooting, and Repair
Quick Unit Status provides information on Devices only and is the version accessed
by users directly from the Configuration and Support menu of the All Controls
window.
All Data Categories is for service personnel and provides information on Devices,
Network, Hardware, Software, Product Options, and the Recorder Destination for
each Information Center and Client.
Device Name is the name assigned to the device when it was added to the network in
!Network Configuration.
Device Category is the type of device.
Model is the specific model or model number of the device (e.g. M3150, CMx
Bedside)
Host Name/MAC Address is the Host Name or MAC Address of the Information
Center the device is connected to.
IP Branch is the IP Address or SDN branch number (0 - 31) of the device (if
applicable).
Status is the operational status of the device (e.g. Online, Offline)
Operating Mode is the device operating mode, if defined (e.g. Monitoring, Demo,
Unknown)
Software Revision is the identifying number of the Philips software release (e.g.
E.xx.xx for current software)
Central Assign. is the name of the central station to which the device is assigned (if
applicable).
CS#/Location is the number of the central station to which the device is assigned (if
applicable) or the Port location of the device.
System Serial # is the serial number of the Information Center system.
Device Serial # is the serial number of the Information Center to which the device is
connected.
Firmware Addr. is the radio firmware address of wireless M3/M4 monitors.
Print in the upper right of the window brings up a Print window that can be used to
print Status Log information to the default printer.