Philips M3150B Installation And Service Manual page 409

Step 4. Select Advanced Options and press Enter to display its menu.
Step 5. Select Erase Non-volatile Memory and press Enter twice.
Step 6. Select Yes, Select to Erase and press Enter.
When prompted that Power Cycle Required!:
Step 7. Reboot the Server by turning the power Off and then On.
Step 8. Repeat Step 1 and Step 2 to re-enter the ROM Based Setup Utility.
Step 9. Select System Options and press Enter to display its menu.
Step 10. Change settings as follows:
– Select NUMLOCK Power-on State and press Enter twice to display its
options: Change its setting to On using the arrow key and press Enter.
– Select Embedded NIC PXE Support and press Enter to display its options:
Change its setting to Disabled using the arrow key and press Enter.
Step 11. Press the keyboard Esc key to return to the ROM Based Setup Utility window.
Step 12. Select PCI Devices and press Enter to display its menu.
Step 13. Change settings as follows:
– Select PCI Embedded Compaq 64-Bit Dual Wide Ultra3 SCSI Adapter
Port 1 and press Enter to display its options:
Change its setting to Disabled using the arrow key and press Enter.
– Select PCI Embedded Compaq 64-Bit Dual Wide Ultra3 SCSI Adapter
Port 2 and press Enter to display its options:
Change its setting to Disabled using the arrow key and press Enter.
Step 14. Press the keyboard Esc key to return to the ROM Based Setup Utility window.
Step 15. Select Boot Controller Order and press Enter to display its menu.
Step 16. Select Ctlr:3 PCI Slot 1 HP Smart Array 641 Controller and press Enter.
Step 17. Select Controller Order 1 and press Enter.
Step 18. Verify that Ctlr1 PPCI Slot 1 is HP Smart Array 641 Controller.
Step 19. Press the keyboard Esc key to return to the ROM Based Setup Utility window.
Step 20. Select Date and Time and press Enter to display its window.
Step 21. Set the Date and Time to present values using the number keys and press Enter.
Step 22. Select Advanced Options and press Enter to display its menu.
Step 23. Change settings as follows:
– Select POST Speed Up and press Enter to display its options:
Change its setting to Disabled using the arrow key and press Enter.
– Select Wake-On LAN and press Enter twice to display its options:
Change its setting to Disabled using the arrow key and press Enter.
Step 24. Press the keyboard Esc key twice to return to the ROM Based Setup Utility.
Maintenance, Troubleshooting, and Repair
Troubleshooting
7-123