Philips M3150B Installation And Service Manual page 347

RECORDER SELF TEST initiates a self-test of the Recorder. The procedure is as
follows:
Step 1. Select the Recorder to be tested by clicking on its location in the rack -- Left
Recorder, Center Recorder, Right Recorder.
Step 2. Click Start Test to initiate the self-test. The Recorder then begins its self-test. The
Recorder will print out codes that indicate its operational status. Explanations of these
codes can be found in the Recorder Service Manual.
Stop Test stops the print test before it has completed.
Recorder Test Status provides messages that assist the procedure and indicate the
status of the self-test and the Recorder's condition.
SDN CARD initiates a self-test of the SDN Card in the Information Center or Client PC
and its branch connections. The procedure is as follows:
Step 1. Click Start Test to initiate the self-tests.
Stop Test stops the SDN card tests before they have completed.
a % complete field indicates the progress of the test.
If the SDN Card self-tests pass, the message SDN Card Testing PASSED appears. Click
OK to continue.
If there is an SDN card self-test failure, the message SDN Card Failure appears.
Maintenance, Troubleshooting, and Repair
Troubleshooting
7-61