Table of Contents
Advertisement
Power
This test verifies the operation of the UPS in providing power in case of a loss of power to the
Failure
Philips system.
Response
Step 1. Disconnect the power cord of the UPS from the wall outlet or Power Distribution
Test
Step 2. Verify that the Philips system continues to operate and the UPS gives and audible
Step 3. Restore the power cord connection.
Step 4. From the All Controls page, select the Service button and enter the service password.
Step 5. Select Support Logs -> Event Logs-> System
Step 6. Review the log and verify that there are two UPS entries at the time of the test: one
Setting
For full compliance with Philips system specifications, the sweep speed of the display(s) shall
Display
be 25mm/s + 10%. Setting this value is required for any new or replaced display, but not for
Sweep
replacement of the video card or video driver.
Speed
The following procedures describe how to make the sweep speed setting. The procedure for
CRT displays is different from that for Flat Panel Displays.
For CRT
Step 1. Set the image on the Primary Display to the Main Screen.
Displays:
Step 2. Access the Image Controls of the Primary Display located in the lower section of the
Step 3. Using the horizontal and vertical image position controls, position the Main
Module for about 3 seconds.
tone.
indicating a power failure was detected, and one indicating that power was restored.
front panel.
Screen image as close to the exact center of the display screen as possible. Center the
image on the CRT screen by eye by equalizing the size of the black boundaries between
the image and the plastic frame. Consult the User's Manual for your display if you are
unsure which controls to use.
Equal
Equal
Start-up and Configuration
Configuring the System
8-5
Advertisement
Table of Contents
Troubleshooting
