Philips M3150B Installation And Service Manual page 428

Troubleshooting
Step 6. Press Enter to create the Logical Drive.
Step 7. Press the keyboard F8 key to Save the configuration.
When Configuration Saved appears:
Step 8. Press Enter to return to the Main Menu.
Step 9. Press the keyboard Esc key to continue the boot process.
Step 10. Insert the FIST disk in to the A:\ drive.
Step 11. Insert the Windows 2000 Operating System CDROM.
Step 12. Cycle power on the Server. Go to "Software Re-Installation Procedure" on page 7-
HP P2478W & P2478U Net Server LC2000:
Step 1. Shutdown and Restart the Server.
During the power restoration cycle, NetRAID firmware initializes. When the Option:
experienced users may press Ctrl+M for HP Net RAID Express Tools now message
appears on the bottom of the screen:
Step 2. Press the keyboard Ctrl-M keys simultaneously to enter the Net RAID Express
Step 3. Delete current RAID configurations as follows:
Step 4. Setup the Logical Drive as follows:
7-142
Maintenance, Troubleshooting, and Repair
The following message appears You have selected a logical drive with a
total datasize of <xx> Gb and RAID 5 fault tolerance.
147.
Tools application.
a. Select Configure in the Management Menu using the up/down arrow keys and
press Enter.
b. Select Clear Configuration and Yes, and then Enter to clear the RAID
configuration
a. Select Configure in the Management Menu and press Enter.
b. Select View/Add/Delete Configuration and Enter to bring up the View/Add
Configuration ARRAY SELECTION MENU.
c. Select (highlight) one of the RAID disks in the CHANNEL-0 window, verify
that its state is Ready, and press the keyboard Spacebar.
d. Repeat verification of the Ready state for each of the RAID disks.
e. Repeat the process to verify that all RAID disks are ONLIN. Press Enter to
EndArray.
f. Press the keyboard F10 key to start the configuration process.
g. Select RAID in the Logical Drive 0 window and Enter.
h. Select RAID level 5 and Enter.
i. Select Accept in the Logical Drive 0 window and Enter to accept the new
settings
j. Select Accept in the Logical Drive 1 window and Enter to accept the new
settings.
k. Select YES in answer to Save Configuration? and Enter to save the settings.
l. Press Enter
m. Press the keyboard Esc key until the Management Menu reappears.