Table of Contents
Advertisement
Troubleshooting
Revision
The Revision window displays the following revision information:
Configuration
The Configuration window displays the following configuration information:
Transmitters
The Transmitters window displays the following information for telemetry transmitters:
ST Parameters
The ST Parameters window displays the following information for ST measurements:
Error Log
The Error Log window displays the following current Error Log information:
NBP Alarm
The NBP Alarm window displays the following Teleframe Settings for NBP Alarms:
7-58
Maintenance, Troubleshooting, and Repair
Mainframe Serial Number
EEPROM Part Number
Software Part Number
Revision Number
Slot Number
Boards in the Mainframe: Slot, Type, Hardware Part Number, Firmware Revision
Receivers for the Mainframe: Slot, Type, Hardware Part Number, Firmware
Revision
SDN Unit Number
SDN Branch Numbers
Language
Transmitter Button
Auto Self Test (on/off)
Self Test Strip (on/off)
GENERAL ALARM PARAMETERS: Alarm Suspend Time, Alarm Reminder
GENERAL ECG PARAMETERS: HR Alarm Limits, Lead Fallback, Extended
Monitoring
M1400X series transmitters: Bandwidth, Lead Selection, Lead Label, Lead
M26xxx series transmitters: Bandwidth, Lead Selection, Lead Label, SpO2
General ST Parameters: ST Module (Enabled/Disabled), ST Alarm Limits
Measurements (ms): ST Module (Enabled/Disabled), ST Alarm Limits
Error Log Information: Card ID, Device ID, Slot, Error Code, Fatal (Yes/No),
A Clear Error Log button is also provided for erasing Error Log information for the
currently selected telemetry mainframe.
NBP Parameter: NBP Param (Enabled/Disabled), Diastolic Alarm (Enabled/
Disabled), Systolic alarm (Enabled/Disabled)
Diastolic Alarm Limits (High, Low)
Swap (on/off)
Alarm Limits
Time, Date
Advertisement
Table of Contents
Troubleshooting
