Table of Contents
Advertisement
DO NOT PRESS the keyboard F10 key.
System Options
Step 9. Select System Options and press Enter to display its menu.
Step 10. Change the following System Options to the values indicated:
Note
If Enabled has been selected, a message will appear. Press Enter again to display its sub
menu and then select Disabled.
Step 11. Press Esc to return to the Setup menu.
PCI Devices
Step 12. Select PCI Devices and press Enter to display its menu.
Step 13. Change the following PCI Devices to the values indicated:
Step 14. Press Esc to return to the Setup menu.
Note
Steps 15 and 16 may be required to satisfy License requirements.
Date and Time
Step 15. Select Time and Date and press Enter to display the Set Time and Date
Step 16. Set the Time and Date (if incorrect) following the instructions given at the bottom
Advanced Options
Step 17. Select Advanced Options and press Enter to display its menu.
Step 18. Change the following Advanced Options to the values indicated:
Step 19. Press Esc to return to the Setup menu.
Step 20. Press Esc again to display the message <F10> to Confirm.
Step 21. Press the keyboard F10 key to save the settings and exit the Setup utility.
Step 22. The system will then reboot.
•
NUMLOCK Power-On State:
•
Embedded NIC Port 1 PXE Support: Disabled
– PCI Embedded Compaq PCI USB Controller:
– PCI Embedded 64 Bit Dual Wide Ultra3 SCSI Adapter Port 1: Disabled
– PCI Embedded 64 Bit Dual Wide Ultra3 SCSI Adapter Port 2: Disabled
– PCI Slot 6 Ethernet Network Controller:
window.
of the screen.
– Hot Plug Resources:
– Post Speed Up:
On
Disabled
Disabled
Maintenance, Troubleshooting, and Repair
Troubleshooting
Disabled
IRQ 11
7-125
Advertisement
Table of Contents
Troubleshooting
