Philips M3150B Installation And Service Manual page 456

Configuring the System
Test Block
Test or Inspection to Perform
Name
Visual For installation, perform visual inspection of shipping
cartons and contents.
Power On: Power on all devices.
Observe software boot up.
Observe that support display shows that the DataServer
Startup was complete.
Performance: Verify purchased options are enabled.
Verify normal system operation.
Do LAN based monitors record and print requests respond
to user inputs?
If #C14 HL7 Export is installed, ping by host name the
target HL7 client device
Safety Is the device connected to a 78581A/B (SCC) or telemetry
mainframe?
Is there a 2nd earth ground connected to the SCC or
telemetry mainframe
Confirm that 78581A/B or telemetry mainframe has
passed Safety Test Block (see 78581A/B or Telemetry
Mainframe Test and Inspection Matrix).
Perform 78581A/B or Telemetry Mainframe Safety
Test Block
8-14
Start-up and Configuration
Table 8-4. M3170 - Test and Inspection Matrix
Expected Results
No visible damage
Expected answer is
"Yes". If so, Visual test
passed.
Devices power up into
expected status on
support display
Expected answers are
"Yes".
If so, Performance test
passed.
Expected answer is
"Yes". If so,
Performance test passed.
If answer is "No", no
Safety test required.
If answer is "Yes",
move to next step.
Expected answer is
"Yes".
If so, Safety test passed.
If answer is "Yes",
Safety test passed.
If answer is "No",
move to next step.
Expected answer is
"Yes". If so, Safety test
passed
What to Record
on Service
Record
V:P or V:F
where P = Pass
F = Fail
PO:P or PO:F
where P = Pass
F = Fail
P:P or P:F
where P = Pass
F = Fail
PHL7:P or PHL7:F
where P = Pass
F = Fail
S:NA
where NA = Not
required
S:P or S:F
where P = Pass
F = Fail
S:P or S:F
where P = Pass
F = Fail
S:P or S:F
where P = Pass
F = Fail