Procedure For Printers; Testing Network Connectivity - Philips M3150B Installation And Service Manual

Procedure for Set the IP Addresses for all connected printers. The procedure is as follows.
Printers
Step 1. Turn On the power of one LaserJet printer with all other printers turned Off.
Step 2. Generate a JetDirect Configuration Page:
(access to print cartridge
Step 3. Make note of the Hardware Address. This address will be used during the Config
Note Each Printer must have an IP Address that is different from all other Printers and taken from
the Required IP Addresses for Printers from Table 6-2.
Testing
Once the IP Addresses of the Server, workstations, switches, Access Points, and printers
Network
have been set, the Network should be tested to assure the integrity of each connection and
Connectivity
that each device can be identified by the Server. The procedure is done at the Server and is
as follows.
Step 1. Click on Start in the lower left of the Windows Main Menu. Select Programs to
a. Press the SELECT button to open the menus.
b. Use the Up or Down button to scroll to INFORMATION, and then press the
SELECT button).
c. Use the Up or Down to scroll to PRINT CONFIGURATION, and then press
the SELECT button.
Top Output Bin
Top cover
and serial/model #)
Tray 1
(pull down)
Paper Level
Indicator
Tray 2
Control Panel
Figure 5-38 LaserJet Printer Controls
Wizard procedure.
show the Programs menu.
Network Names and IP Addresses
Hardware Installation
5-43