Recreating Fist Bootable Floppy Disk - Philips M3150B Installation And Service Manual

Troubleshooting
Step 5. Verify the Write Policy settings as follows:
Step 6. Verify the SCSI Transfer Rate settings as follows:
Step 7. Verify disk settings as follows:
Step 8. Press the keyboard Esc key to return to the Management Menu.
Step 9. Press the Esc key again.
Step 10. Select YES in answer to Exit? and Enter.
Step 11. Reinstall Windows Operating System and Philips Application software
Recreating FIST If the FIST bootable floppy disk is lost or damaged, it can be recreated at any Information
Bootable Floppy Center, Client, or the Server from the Philips software CD ROM.
Disk
7-144
Maintenance, Troubleshooting, and Repair
c. Select (highlight) one of the RAID disks in the CHANNEL-0 window, verify
that its state is Ready, and press the keyboard Spacebar.
d. Repeat verification of the Ready state for each of the RAID disks.
e. Repeat the process to verify that all RAID disks are ONLIN.
f. Press the keyboard F10 key to start the configuration process.
g. Select RAID in the Logical Drive 0 window and Enter.
h. Select RAID level 5 and Enter.
i. Select Accept in the Logical Drive 0 window and Enter to accept the new
settings
j. Select Accept in the Logical Drive 1 window and Enter to accept the new
settings.
k. Select YES in answer to Save Configuration? and Enter to save the settings.
l. Press Enter
m. Press the keyboard Esc key until the Management Menu reappears.
a. Select Objects in the Management Menu and Enter.
b. Select Logical Drive and Enter.
c. Select Properties and Enter.
d. Select Write Policy and Enter.
e. Select WRBACK and Enter.
f. Press the keyboard Esc key until the Object Menu appears.
a. Select SCSI Channel in the Object Menu and Enter.
b. Select Channel 0 and Enter.
c. Select SCSI Transfer Rate and Enter.
d. Select ULTRA-2 and Enter.
e. Select YES and Enter.
f. Press the keyboard Esc key until the Management Menu appears.
a. Select Initialize in the Management Menu and Enter.
b. Select Logical Drive 0 and press the keyboard Spacebar.
c. Press the keyboard F10 key to start the initialization.
d. Select YES in answer to Initialize Drive? and Enter.
e. Press any keyboard key when the prompt appears at the bottom of the screen.
following procedures provided in this chapter.