Hp D5000A Net Server Lh3 - Philips M3150B Installation And Service Manual

Step 5. Press ESC twice.
Step 6. Select EXIT Saving Changes, then Enter and select Yes.
Step 7. Store the BIOS floppy disk and place it into the plastic holder on the side of the
Step 8. Continue the OS installation procedure described in Operating System
Note The D5000A LH3 Server is not supported on E.01 systems. These BIOS settings are here for
reference only. They apply to E.0.
HP D5000A Net Step 1. Properly shutdown and restart the Server. During bootup, Press F2 to enter
Server LH3:
Step 2. Select Yes and press Enter to display the Phoenix BIOS System Configuration
Step 3. Select User Preferences using the keyboard right arrow key.
Step 4. Select the Included SCSI-B channel using the down arrow key and press Enter.
Step 5. Change the value to Yes using the up/down arrow keys and press Enter.
Step 6. Press the right arrow key twice to move to the Configuration menu.
Step 7. Select Integrated I/O Ports and press Enter to access its menu.
Step 8. Select Serial Ports and press Enter to access its menu.
Step 9. Select Serial Port B and press Enter.
Step 10. If no external modem is connected, change its value to Disabled using the up/
Step 11. Select Management Port using the down arrow key and press Enter.
Step 12. Change its value to Disabled using the up/down arrow keys and press Enter.
Step 13. Press the keyboard ESC key twice to return to the Configuration menu.
Step 14. Select PCI Slot Devices and Enter.
Step 15. Select PCI IRQ Locking and Enter.
Step 16. Select Routing Algorithm and Enter.
Step 17. Select Fixed and Enter.
Step 18. Select INTA for Slots 1& 5 and Enter.
Step 19. Select IRQ 15 and Enter. (Note: Slot 1 may contain an optional internal modem)
• Select Boot Settings and press Enter
– select QuickBoot Mode and change to
NetServer. It is recommended that you make a copy of the BIOS on another floppy
disk in a safe and secure place.
Installation in this chapter.
Setup.
window.
down arrow keys and press Enter. If an external modem is connected, change its
value to Enabled, 2F8, IRQ3 and press Enter.
[Disabled]
Maintenance, Troubleshooting, and Repair
Troubleshooting
7-127