Locating System Components - Philips M3150B Installation And Service Manual

Locating System Components

Locating System Components
This section describes proper installation of the components of the Information Center
system in their intended locations, including the assembly and installation of mounting
hardware. The procedure for a particular installation depends on the planned locations of
individual components developed during site planning and preparation in Chapter 4.
Hence, this section will only give general procedures for locating individual components
and must be adapted for each installation.
Components on
Information Center components to be located on the work surface of the clinical work
the Work
station are simply placed on the work surface in their intended locations. As a minimum,
Surface
these include the primary display(s), the keyboard, and the mouse (or trackball), but may
also include the recorders, speaker, printer, processing unit, and UPS.
Typical Units placed on the work surface should be positioned in the manner most convenient for
Installations use by clinicians. Figure 5-5 shows a typical work surface installation of the Information
Center with dual display and optional printer and 4-Channel Recorder. The PC workstation
and UPS are located inside the wall mount hardware, which is attached to the wall of the
clinical workstation.
Display Swivel A Swivel Mount Option (PN M3180A #A05) is also available for medium CRT displays to
Mount provide 270
drilling a hole in the work surface for the display's power cord and cables and securing the
hardware to the surface with screws.
5-6
Hardware Installation
Wall Mounted PC Workstation and UPS
Figure 5-5 Information Center Installation with PC/UPS Wall Mount
o
swivel capability (not supported for large CRT displays). Installation requires
Remote
Display