Philips M3150B Installation And Service Manual page 436

Troubleshooting
Step 8. If the FIST disk has already been used to configure the device, the stored device
Step 9. The settings are displayed, as shown in Figure 7-63. If the information is correct,
Step 10. Follow the prompts on the screen to start the OS installation.
Caution You must remove the floppy disk before the PC reboots. If you don't, then you must
reinstall the Windows OS again from Step 1.
7-150
Maintenance, Troubleshooting, and Repair
information is displayed, as shown in Figure 7-63. If the information is not for the
current device, press N at the prompt to reconfigure the settings (see step 7). If the
information is correct, press Y to continue (and go to step 9).
Philips IntelliVue Information Center
Created: 05/21/2003 - 18:36:13
Product = 862067
PCType = CPQ07E8
PCSerNum
= X224KN8ZA019
ProdSerNum = 0987654321
PCName = X224KN8ZA019
= 172.31.204.89
IP
Subnet = 255.255.0.0
Option = FLD
Option = ABA
Figure 7-63 Device Information Window
press Y and enter to continue. If the information is incorrect press N and enter to re-
enter the correct values.
• After approximately 15-20 minutes into the XP OS installation, an error message
opens stating "Unattended Setup is unable to continue because set-up parameter
specified by your system administrator or computer manufacturer is missing or
invalid. Setup must therefore ask you to provide this information. Once you
have furnished the required information, unattended setup operation will
continue."
• Press OK to close the error window.
• In the Windows XP Professional Setup window, enter the Product Key and press
Next. The Product key is located on the COA (Certificate of Authenticity) label that is
provided in the upgrade kit. Attach the COA label to the PC over any existing COA
labels.
;Compaq Evo D510 CMT
;System Serial Number
;Hostname
;field installation
;language