Information Centers And Clients - Philips M3150B Installation And Service Manual

Configuring the System
Information Table 8-3 describes the test or inspection to perform for each Information Center and
Centers and Client for each type of test specified in Table 8-2.
Clients
Note Detailed procedures for performing the tests in the tables are given in the previous sections of
Testing Product Assurance.
Table 8-3. M3150/M3155/M3151 - Test and Inspection Matrix
Test Block
Test or Inspection to Perform
Name
Visual 1. For installation, perform visual inspection of
shipping cartons and contents.
All other cases, inspect installed device.
2. Is the speaker cable securely fastened?
3. If a Keyboard-Video-Mouse Switch is installed, are
keyboard and mouse cables securely fastened to the
rear of the KVM switch with cable ties?
Power On: Power on all devices.
Observe software boot up.
Observe that resting display shows appropriate
information for device configuration and options.
Observe that all lights visible from the front panels are in
proper status
If Elo Touch flat panel display is installed, were onscreen
display and display power controls disabled?
8-12
Start-up and Configuration
Table 8-2. M3150/M3151/M3155/M3170/M3154/M3169/M3185 Test and
Service Event
When performing....
Installation
Preventive Maintenance
Any component repair or replacement
Hardware Upgrade
Software Upgrade
All other Service Events
Inspection Requirements
Test Block(s) Required
....Complete these tests
Visual, Power On, Performance, Safety
Visual
Power On, Performance, Safety
Power On, Performance, Safety
Power On, Performance
Visual, Performance
Expected Results
No visible damage
Expected answer is
"Yes". for steps 1 - 3. If
so, Visual test passed.
Devices power up into
expected resting display
status
Select onscreen display
and power controls and
no visual changes occur
on screen
What to Record
on Service
Record
V:P or V:F
where P = Pass
F = Fail
PO:P or PO:F
where P = Pass
F = Fail