Philips M3150B Installation And Service Manual page 338

Troubleshooting
Setting
Terminal Type
Screen Refresh Interval (sec)
Displayed Events
Baud Rate
Flow Control
Session Inactivity Time (min)
Spanning Tree Operation*
* The Spanning Tree Operation values are not shown in this window. To see the Spanning
Tree values, you must use a HyperTerminal connection. The PC must meet the following
requirements.
•
•
•
If the PC is the Database Server using Hyperterminal from Port A, the UPS connection must
be temporarily removed and disabled. The following steps describe the procedure.
Step 1. Plug one end of the 9-pin D female - 9-pin D female cable into the RS 232 connector
Step 2. Plug the other end of the cable into the CONSOLE port on the front of the HP
Step 3. Turn On the PC and Switch
If the Server's UPS service detects that the UPS is not connected to Serial Port A, a message
indicating At least one service failed to initialize... may appear.
If this message appears:
Step 4. Click OK and proceed to Step 11.
If this message does not appear:
Step 5. Go to the Windows Main Menu and click on Start / Settings / Control Panel
Step 6. Scroll down the list of Services to UPS.
Step 7. Click on UPS to highlight it.
Step 8. Click on the Stop button to disable the UPS connection.
Step 9. Click Yes to the Are you sure.. message. A momentary Attempting to stop...
When the UPS connection has been disabled:
Step 10. Close the Services window and Control Panel.
7-52
Maintenance, Troubleshooting, and Repair
Table 7-9. Configuration Parameters
Factory Default
VT100
3
All
speed-sense
XON/XOFF
0
Microsoft Operating System software (Windows 98 or Windows NT)
200 MHz or faster
RS 232 serial interface port (9-Pin D type connector)
of the configuring PC
ProCurve 2524 switch.
and double click on the Services icon (2 gears) to open the Services window.
message will then appear.
Recommended (Configured)
ANSI
3
All
speed-sense
XON/XOFF
10