ABB IRB 7600 Series Product Manual page 86

2 Installation and commissioning
2.5.7 Orienting and securing the robot
Continued
Securing the robot
Use this procedure to secure robot to base plate after fitting plate to the foundation.
1
2
3
4
5
6
Continues on next page
86
Action
Lift the robot.
Move robot to the vicinity of its installation loca-
tion.
Fit two guide sleeves to the guide sleeve holes
in the base plate.
Guide the robot gently using two M24 screws
while lowering it into its mounting position.
Fit the bolts and washers in the base attach-
ment holes.
Tighten bolts in a criss-cross pattern to ensure
that the base is not distorted.
© Copyright 2007 - 2018 ABB. All rights reserved.
Note
See section Lifting robot with lifting
slings on page 73.
See section Lifting robot with round-
slings on page 75.
Shown in figure Base plate, guide
sleeve holes on page 83.
Note
One of the guide sleeve holes is
elongated!
Make sure the robot base is correctly
fitted onto the guide sleeves!
Specified in Attachment screws on
page 85.
Shown in figure Illustration, robot fitted
to base plate on page 85.
Note
Lightly lubricate screws before as-
sembly!
Product manual - IRB 7600
3HAC022033-001 Revision: V