Table of Contents
Advertisement
Revision
K
L
M
N
Product manual - IRB 7600
3HAC022033-001 Revision: V
Description
•
Added inspection of oil level in gearboxes and inspection of surface
treatment in maintenance schedule for Foundry Prime. See section
Activities and intervals, Foundry Prime.
•
Text in maintenance schedules concerning lubrication of balancing
device bearing changed into concerning all bearings of the balancing
device, see
Maintenance schedule on page
•
Replacement of cable harness in Foundry Prime robots added to
maintenance schedule, see Activities and intervals, Foundry Prime.
This revision includes the following updates:
•
Removed incorrect article number for fork lift, see
lift on page
67.
•
Information about restricting and extending the working range of axis
1 is now separated, see
axis 1 on page 106
1 (option 561-1) on page
section
Inspecting the axis-1 mechanical stop pin on page
This revision includes the following updates:
•
A new block, about general illustrations, added in section
the product manual on page
•
Made minor corrections and improvements in the complete instruction
for how to replace the axis 1 gearbox, see
on page
350.
•
Robot designations are adjusted in sub-headings in section
transportation precautions on page
•
Added new mechanical structure of the lower arm attachment point for
robots with protection Foundry Plus and Foundry Prime, see
ment of complete lower arm on page
of lower arm shaft on page 273
2 in Product manual, spare parts - IRB 7600.
•
Some general tightening torques have been changed/added, see up-
dated values in
Screw joints on page
•
Added
Safety risks during handling of batteries on page
•
The maximum allowed deviation in levelness of the base plate is
changed, see
Securing the base plate on page
•
Reference to Hilti standard added to the foundation recommendation
for the base plate and class designation for foundation is changed to
european standard C25/C30 (previously Swedish standard K25/K30),
see
Securing the base plate on page
•
Added attachment plate for axis-2 switch to equipment list, see
ation of position switches (option) on page
•
Friction washer added to the instruction for replacing axis-2 gearbox
and to the exploded view, see
page 362
and Exploded view.
•
Moved all information about Foundry Prime to a separate Product
manual, see
References on page 10
•
Corrected article numbers for the o-rings and removed the removal tool
from the equipment list and from the procedure, see
gearbox, axis 6 on page
•
Corrected article number for axis-2-3 sealing, see
complete lower arm on page 264
arm on page
259.
This revision includes the following updates:
•
A new SMB unit and battery is introduced, with longer battery lifetime.
This revision includes the following updates:
•
Instruction for inspection of oil level updated.
•
Spare part number, motor axis 2 corrected.
© Copyright 2007 - 2018 ABB. All rights reserved.
Overview of this manual
133.
Mechanically restricting the working range of
and the new section
Extended working range, axis
95. Also added signal about option 561-1 in
19.
Replacing the axis 1 gearbox
52.
264, the new section
and the exploded view Frame-Lower arm
435.
80.
113.
Replacement of gearbox, axis 2 on
for document number.
389.
and
Replacement of complete upper
Continues on next page
Continued
Lifting robot with fork
167.
How to read
Robot
Replace-
Replacement
40.
80.
Install-
Replacement of
Replacement of
13
Advertisement
Table of Contents
