Reading The Sis Output Logs - ABB IRB 7600 Series Product Manual

3.7.5 Reading the SIS output logs

General
Whenever a set condition has expired (e.g. max allowed operation time before
service), a message to this effect will be shown in the Operational log.
Access to logs
How to open a log and show its contents is detailed in the User's Guide, chapter
Service.
Available messages
The following messages may be shown:
Available in:
Calendar time
Calendar time
Operation time
Operation time
Gearbox time
Gearbox time
Product manual - IRB 7600
3HAC022033-001 Revision: V
SIS message in the
log:
Service Message
Service is due!
X calendar days
since last service.
Service Message
X calendar days to
next service.
Service Message
Service is due!
X production hours
since last service.
Service Message
X production hours
to next service.
Service Message
Gearbox x requires
service!
Service Message
X% of the service in-
terval has expired for
gearbox x!
© Copyright 2007 - 2018 ABB. All rights reserved.
3.7.5 Reading the SIS output logs
Meaning:
The manually set calendar time limit has expired.
How to set the limit is detailed in section
the SIS parameters on page
Proceed with the required service as detailed in
chapter Repair on page 225
on page 131 depending on which type of service.
X number of calendar days remain until the
manually set calendar time limit expires.
How to set the value determining when the mes-
sage is to be shown, is detailed in section
the SIS parameters on page
The manually set operation time limit has expired.
How to set the limit is detailed in section
the SIS parameters on page
Proceed with the required service as detailed in
chapter Repair on page 225
on page 131 depending on which type of service.
X number of operation hours remain until the
manually set operation time limit expires.
How to set the value determining when the mes-
sage is to be shown, is detailed in section
the SIS parameters on page
The automatically calculated gearbox time limit
has expired.
Proceed with the required service as detailed in
chapter Repair on page 225
on page 131 depending on which type of service.
X percent of gearbox hours remain until the auto-
matically calculated gearbox time limit expires.
How to set the value determining when the mes-
sage is to be shown, is detailed in section
the SIS parameters on page
3 Maintenance
Setting
222.
or chapter Maintenance
Setting
222.
Setting
222.
or chapter Maintenance
Setting
222.
or chapter Maintenance
Setting
222.
223