Table of Contents
Advertisement
3 Maintenance
3.6.2 Cleaning the IRB 7600
3.6.2 Cleaning the IRB 7600
General
To secure high uptime it is important that the IRB 7600 is cleaned regularly. The
frequency of cleaning depends on the environment in which the product works.
Different cleaning methods are allowed depending on the type of protection of the
IRB 7600.
Oil spills
Oil spills from gearboxes
Use the following procedure if any oil spills are detected that can be suspected to
originate from a gearbox.
Oil spills discolors painted surfaces
Oil spills on painted surfaces of the robot can result in discoloration.
Special cleaning considerations
This section specifies some special considerations when cleaning the robot.
Continues on next page
214
WARNING
Turn off all electrical power supplies to the manipulator before entering its work
space.
Note
Always verify the protection type of the robot before cleaning.
1 Inspect that the oil level in the suspected gearbox is according to the
recommendations, see
2 Write down the oil level.
3 Inspect the oil level again after, for example, 6 months.
4 If the oil level is decreased then replace the gearbox.
Note
After all repair and maintenance work involving oil, always wipe the robot clean
from all surplus oil.
•
Always use cleaning equipment as specified. Any other cleaning equipment
may shorten the life of the robot.
•
Always check that all protective covers are fitted to the robot before cleaning.
•
Never point the water jet at connectors, joints, sealings, or gaskets.
•
Do not use compressed air to clean the robot.
•
Never use solvents that are not approved by ABB to clean the robot.
•
Do not spray from a distance closer than 0.4 m.
© Copyright 2007 - 2018 ABB. All rights reserved.
Inspection activities on page
138.
Product manual - IRB 7600
3HAC022033-001 Revision: V
Advertisement
Table of Contents
