Table of Contents
Advertisement
3.7 Service Information System, M2000
3.7.1 Using the SIS system
General
This is a brief description of how to use the Service Information System, SIS for
M2000 robot systems. Details may be found in:
The section is only valid for M2000 systems. For information regarding M2004
robot systems, see additional documentation, Operating manual - Service
Information System. Article number is specified in section
Basic procedure
1
2
3
4
5
6
7
Product manual - IRB 7600
3HAC022033-001 Revision: V
•
Service Information System, SIS
•
Defining the SIS input parameters
•
Setting the SIS parameters
•
Importing/exporting SIS data
•
Reading the SIS output logs
Action
Determine which of the system functions
you require.
Define what values are adequate and suit-
able for your application in your production
environment.
Enter these parameters in the system.
Run the robot in normal operation.
Reset the counter if a repair is made, or if a
counter for any other reason is restarted.
When a time limit, set in the parameters, is
exceeded, a message may be read on the
Tech Pendant Unit (TPU).
If the log containing the message is to be
available from an external PC, or if the SIS
parameters are to be entered from an extern-
al PC, a set of software tools are available
to build such an application.
© Copyright 2007 - 2018 ABB. All rights reserved.
3 Maintenance
3.7.1 Using the SIS system
References on page
Reference
These are described in
Description of
Service Information System (SIS) on
page
218.
Recommendations on how to define these
are given in
SIS system parameters on
page
221.
How to do this is detailed in
SIS parameters on page
222.
The TPU displays for resetting any SIS
value are shown in
Description of Service
Information System (SIS) on page
How to access this is detailed in
the SIS output logs on page
These are described in
Exporting the SIS
data on page
224.
10.
Setting the
218.
Reading
223.
217
Advertisement
Table of Contents
