How To Read The Product Manual - ABB IRB 7600 Series Product Manual

How to read the product manual

Reading the procedures
The procedures contain references to figures, tools, material, and so on. The
references are read as described below.
References to figures
The procedures often include references to components or attachment points
located on the manipulator/controller. The components or attachment points are
marked with italic text in the procedures and completed with a reference to the
figure where the current component or attachment point is shown.
The denomination in the procedure for the component or attachment point
corresponds to the denomination in the referenced figure.
The table below shows an example of a reference to a figure from a step in a
procedure.
8.
References to required equipment
The procedures often include references to equipment (spare parts, tools, etc.)
required for the different actions in the procedure. The equipment is marked with
italic text in the procedures and completed with a reference to the section where
the equipment is listed with further information, that is article number and
dimensions.
The designation in the procedure for the component or attachment point
corresponds to the designation in the referenced list.
The table below shows an example of a reference to a list of required equipment
from a step in a procedure.
3.
Safety information
The manual includes a separate safety chapter that must be read through before
proceeding with any service or installation procedures. All procedures also include
specific safety information when dangerous steps are to be performed.
Read more in the chapter
Illustrations
The robot is illustrated with general figures that does not take painting or protection
type in consideration.
Likewise, certain work methods or general information that is valid for several robot
models, can be illustrated with illustrations that show a different robot model than
the one that is described in the current manual.
Product manual - IRB 7600
3HAC022033-001 Revision: V
Action
Remove the rear attachment screws, gearbox.
Action
Fit a new sealing, axis 2 to the gearbox.
Safety on page
© Copyright 2007 - 2018 ABB. All rights reserved.
How to read the product manual
Note/Illustration
Shown in the figure
gearbox on page
Note/Illustration
Art. no. is specified in
equipment on page xx.
21.
Location of
xx.
Required
19