Verifying The Calibration - ABB IRB 7600 Series Product Manual

Hide thumbs Also See for IRB 7600 Series:

Table of Contents

5 Calibration

5.6 Verifying the calibration

Introduction

Always verify the results after calibrating any robot axis to verify that all calibration

positions are correct.

Verifying the calibration

Use this procedure to verify the calibration result.

Run the calibration home position program twice.

Do not change the position of the robot axes after running

the program!

Adjust the synchronization marks when the calibration is

done, if necessary.

Write down the values on a new label and stick it on top

of the calibration label.

The label is located on the lower arm.

Remove any calibration equipment from the robot.

Checking the synchron-

ization position on page

This is detailed in section

Synchronization marks and

synchronization position for

axes on page

Product manual - IRB 7600

3HAC022033-001 Revision: V