Bearers Handling +Wipbr - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
9.3.1.7. Notes
It is recommended to change the default settings of the WIP stack using +WIPCFG only when it is
required. Changing the parameter values especially the max number of sockets and the max TCP
buffer size with high values leads to over consumption of the stack memory which causes the
firmware to crash. Hence, care must be taken when the default settings of the stack is changed using
the +WIPCFG command.
The following option values set by the +WIPCFG command are taken into consideration at run time.
The option values
AT_WIP_NET_OPT_ESC_SEQ_NOT_SENT) will be taken into consideration at the next start up only
if these are saved in non-volatile memory before stopping the stack.
WIP_NET_OPT_IP_TTL
WIP_NET_OPT_IP_TOS
WIP_NET_OPT_IP_FRAG_TIMEO
WIP_NET_OPT_TCP_MAXINITWIN
WIP_NET_OPT_TCP_MIN_MSS
WIP_NET_OPT_DEBUG_PORT
AT_WIP_NET_OPT_PREF_TIMEOUT_VALUE
AT_WIP_NET_OPT_ESC_SEQ_NOT_SENT
AT_WIP_NET_OPT_AUTO_SWITCH
9.3.2.

Bearers Handling +WIPBR

9.3.2.1. Description
The +WIPBR command can be used to:
select the bearer
start/close the bearer
configure different bearer options such as access point name
9.3.2.2. Syntax
if <cmdtype> = 0,1 or 5
Action Command
AT+WIPBR=<cmdtype>,<bid>
OK
if <cmdtype> = 2
Action Command
AT+WIPBR=<cmdtype>,<bid>,<opt num>,<value>
OK
WA_DEV_WISMO_UGD_012
below (except for
Rev 004
AT_WIP_NET_OPT_PREF_TIMEOUT_VALUE
TCP/IP Commands
November 3, 2011
and
174