Request Packet Domain Ip Service „D; Cgerep Packet Domain Event Reporting - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
3.10.13. Request Packet Domain IP service „D‟
Description
Request packet domain
IPservice
Parameters
<cid>
1..3
Clarification
If <cid> omitted, default <cid> (3) will be used.
If <cid> correspond to an already active PDP context (activated with +CGACT command) ERROR will
be returned, the PDP must be in quiescent state before ATD*9x.

3.10.14. +CGEREP Packet Domain event reporting

Description
Set +CGEV notification
mode
Get current settings
Get supported values
Parameters
<mode>
0 (default)
1
2
<bfr>
0 (default)
1
WA_DEV_WISMO_UGD_012
Command
D*98[*<cid>]#
Description
PDP Context Identifier
Command
+CGEREP=[<mode>[,<bfr>]]
+CGEREP?
+CGEREP=?
Description
Buffer unsolicited result codes in the MT; if MT result code buffer is full, the oldest ones
are discarded.
Discard unsolicited result codes when MT TE link is reserved (e.g. in on line data
mode); otherwise forward them directly to the TE
Buffer unsolicited result codes in the MT when MT TE link is reserved (e.g. in on line
data mode) and flush them to the TE when MT TE link becomes available; otherwise
forward them directly to the TE
Description
MT buffer of unsolicited result codes defined within this command is cleared when
<mode> 1 or 2 is entered
MT buffer of unsolicited result codes defined within this command is flushed to the TE
when <mode> 1 or 2 is entered
Rev 004
3GPP TS 27.007 Commands
Possible Response(s)
CONNECT
+CME ERROR: <err>
Possible Response(s)
OK
+CME ERROR: <err>
+CGEREP: <mode>,<bfr>
OK
+CME ERROR: <err>
+CGEREP: (list of supported
<mode>s),(list of supported <bfr>s)
OK
+CME ERROR: <err>
November 3, 2011 97