Cgcmod Pdp Context Modify; Cgdata Enter Data State - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23

3.10.6. +CGCMOD PDP Context Modify

Description
Request PDP context
modification
Get active PDPs
Parameters
<cid>
1..3
Clarification
Recommendation specifies that after the command has completed, the MT returns to online data state
From a Sierra Wireless point of view, +CGCMOD behaviour is more similar to +CGACT command,
hence the implementation choice is not to switch link to online data mode after PDP context
modification.
TE will have to send +++ escape sequence to switch channel to online command if +CGCMOD
cannot be performed from another AT channel. TE will have to use O command, if required, to switch
channel to online data mode.

3.10.7. +CGDATA Enter data state

Description
Enter data state
Get supported values
Parameters
<L2P>
"PPP"
<cid>
1..3
Clarification
If no parameters are provided (i.e +CGDATA<CR>), the last <cid> activated with +CGACT or the
default <cid> is used.
WA_DEV_WISMO_UGD_012
Command
+CGCMOD=[<cid>[,<cid>[,...]]]
+CGCMOD=?
Description
PDP Context Identifier
Command
+CGDATA[=<L2P>,[<cid>]]
+CGDATA=?
Description
Point-to-point protocol for a PDP such as IP
Description
PDP Context Identifier
Rev 004
3GPP TS 27.007 Commands
Possible Response(s)
OK
+CME ERROR: <err>
+CGCMOD: (list of <cid>s associated
with active contexts)
OK
+CME ERROR: <err>
Possible Response(s)
CONNECT
+CME ERROR: <err>
+CGDATA: (list of supported <L2P>s)
OK
+CME ERROR: <err>
.
November 3, 2011 92