AT Command Manual for Firmware L23
Parameters
<type>
0 (default value)
<speed>
9600
4.1.8.
P Pulse dialing
Description
Pulse dialing
Clarification
This command is supported for compatibility purpose and has no effect on ME (simple response OK).
4.1.9.
S0 Automatic Answer
Description
Set automatic answer
Read current register value
Parameters
<num>
0 (default)
1..255
Clarification
The <num> parameter is saved into non-volatile memory by AT&W command and restored to default
value by AT&F command.
4.1.10. S6 Pause before blind dialing
Description
Set pause duration
WA_DEV_WISMO_UGD_012
Description
Return to online data state from online command state.
Description
Data rate
Command
P
Command
S0=<num>
S0?
Description
No automatic answer
Number of rings the modem will wait for before answering the phone if a ring is
detected
Command
S6=<time>
Rev 004
ITU-T V25.ter Commands
Possible Response(s)
OK
Possible Response(s)
OK
+CME ERROR: <err>
<num>
OK
+CME ERROR: <err>
Possible Response(s)
OK
+CME ERROR: <err>
November 3, 2011
102