Pschru Channel Registration Urc - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
Clarification
The module sends the unsolicited code once after the boot process +PSSUP: <stat>
The PSSUP notification will not be sent if the module is in autobaud mode and no bytes have been
received from TE to adapt the serial link to the actual speed.
If the command fails in an MT error, +CME ERROR: <err> is returned. Test command returns
supported values.
+PSSREP parameter is automatically saved into non-volatile memory.
The <act> parameter is restored to default value by AT&F command.
8.6.4.

*PSCHRU Channel registration URC

Description
Set URC filter
Get current channel filter
Get supported masks
Description
Set command is used to filter one or several type of URC on a channel. By default all URC types are
enabled on a newly opened channel.
This command only applies on the channel it is submitted, other channels are not impacted.
Depending of <mask> value, URC will or will not be broadcasted on the channel.
Parameters
<mask>
0
1
2
4
8
16
32
64
128
WA_DEV_WISMO_UGD_012
Command
*PSCHRU=<mask>
*PSCHRU?
*PSCHRU=?
Description
No URC sent on the channel
Call related URC to be sent on the channel:
RING, +CRING, +CCCM, +CCWV, +CCWA, +CLIP, +COLP, +CSSI, +CSSU,
*PSCALL, *PSDCI, *PSCSC, *PSCN
SMS related URC to be sent on the channel:
+CDS, +CMT, +CMTI
CBM related URC to be sent on the channel:
+CBM
ME status related URC to be sent on the channel:
+CIEV
Network registration related URC to be sent on the channel:
+CREG, +CGREG
SS related URC to be sent on the channel:
+CUSD
Initialisation related URC to be sent on the channel:
*PSREADY
Debug related URC to be sent on the channel.
Rev 004
Proprietary AT Commands
Possible Response(s)
OK
+CME ERROR: <err>
*PSCHRU: <mask>
OK
+CME ERROR: <err>
*PSCHRU: (list of supported <mask>s)
OK
+CME ERROR: <err>
November 3, 2011 143