Ping Services; Ping Command +Wipping - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
internal timer expires. The timeout period is configurable through the
socket is unmapped, shut down or closed.
In some scenarios, there might be a segmentation of data packets because of timer expiration,
network problems, etc. Thus, a single packet of data may be received in more than one packet at the
peer.
9.5.1.10.5.
This feature for UDP is supported only in case of continuous transparent mode. If the +WIPDATA
parameters used for packet segmentation can be configured using the +WIPDATA command. In case
they are not configured using the +WIPDATA command, the default value of these parameters will be
used.
In some scenarios, there might be a segmentation of data packets because of timer expiration,
network problems, etc. Thus, a single packet of data may be received in more than one packet at the
peer.
9.6.

Ping Services

9.6.1.

PING command +WIPPING

9.6.1.1. Description
The +WIPPING command is used to configure different PING parameters and to send PING requests.
9.6.1.2. Syntax
Action Command
AT+WIPPING=<host>,[<repeat>],[<interval>],[<timeout>],[<nwrite>],[<ttl>]
OK
Read Command
AT+WIPPING?
OK
Test Command
AT+WIPPING=?
OK
WA_DEV_WISMO_UGD_012
P_NET_OPT_PREF_TIMEOUT_VALUE) or +WIPDATA command.
Packet Segmentation in UDP Sockets
Rev 004
TCP/IP Commands
November 3, 2011 198