AT Command Manual for Firmware L23
Description
This command is used to get the number of remaining PIN and PUK attempts.
Set command has no effect (returns OK).
Parameters
<pin1>
0..3
<pin2>
0..3
<puk1>
0..10
<puk2>
0..10
<code>
SIM PIN1
SIM PIN2
SIM PUK1
SIM PUK2
8.6.2.
*PSSEAV Service Availability
Description
Set mode
Get current mode
Get supported modes
Description
Set command enables/disables the presentation of notification result code from ME to TE. When
<mode>=1, *PSREADY result code is sent to TE when <service> is available.
Read command is used to get current mode and to check which service are already available
(*PSREADY is returned only for available services).
WA_DEV_WISMO_UGD_012
Description
Number of remaining attempts for PIN 1
Description
Number of remaining attempts for PIN 2
Description
Number of remaining attempts for PUK 1
Description
Number of remaining attempts for PUK 2
Description
PIN 1 identifier
PIN 2 identifier
PUK 1 identifier
PUK 2 identifier
Command
*PSSEAV=<mode>
*PSSEAV?
*PSSEAV=?
Rev 004
Proprietary AT Commands
Possible Response(s)
OK
+CME ERROR: <err>
*PSSEAV: <mode>
[<CR><LF>*PSREADY: <service>]
[[...]<CR><LF>*PSREADY: <service>]
OK
+CME ERROR: <err>
*PSSEAV: (list of supported <mode>s), (list of
supported <service>s)
OK
+CME ERROR: <err>
November 3, 2011
141