Cops Operator Selection - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
Description
Get supported values
Parameters
<n>
0 (default)
1
2
Omitted
<stat>
0
1
2
3
4
5
<lac>
String type
<ci>
String type
Clarification
+CREG parameter is automatically saved into non-volatile memory.
The <n> parameter is restored to default value by AT&F command.
Using the <alphax> parameter will return an empty string as this parameter is not supported.
3.4.3.

+COPS Operator Selection

Description
Select operator
Get current mode
and operator
WA_DEV_WISMO_UGD_012
Command
+CREG=?
Description
Disable network registration unsolicited result code
Enable network registration and location information unsolicited result code +CREG:
<stat>
Enable network registration and location information unsolicited result code +CREG:
<stat>[,<lac>,<ci>]
Use previous value
Description
Not registered, MT is not currently searching a new operator to register to
Registered, home network
Not registered, but MT is currently searching a new operator to register to
Registration denied
Unknown
Registered, roaming
Description
Two bytes location area code in hexadecimal format (e.g. "00C3" equals 195 in
decimal)
Description
Two bytes cell ID in hexadecimal format
Command
+COPS=[<mode>[,<format>[,<oper>[,<
AcT>]]]]
+COPS?
Rev 004
3GPP TS 27.007 Commands
Possible Response(s)
+CREG: (list of supported <n>s)
OK
Possible Response(s)
OK
+CME ERROR: <err>
+COPS: <mode>[,<format>, <oper>[,< AcT>]]
OK
+CME ERROR: <err>
November 3, 2011 44