AT Command Manual for Firmware L23
Parameters
<time>
0..999
Clarification
This command is supported for compatibility purpose and has no effect on ME (simple response OK).
4.1.11. S7 connection completion timeout
Description
Set timeout
Read current register value
Parameters
<time>
1..255
4.1.12. S8 Comma dial modifier
Description
Set time
Read current register value
Parameters
<time>
0..255
Clarification
Comma is not supported in dial string; this command has no effect on ME (simple response OK).
WA_DEV_WISMO_UGD_012
Description
Time
Command
S7=<time>
S7?
Description
Amount of time the modem will wait for the carrier signal from the remote modem. If a
carrier is not received in this time, the modem will hang up and send the NO CARRIER
result code.
Command
S8=<time>
S8?
Description
Amount of time the modem will pause when it detects a comma in the dialing string
Rev 004
ITU-T V25.ter Commands
Possible Response(s)
OK
+CME ERROR: <err>
<time>
OK
+CME ERROR: <err>
Possible Response(s)
OK
+CME ERROR: <err>
<time>
OK
+CME ERROR: <err>
November 3, 2011
103