Cfun Set Phone Functionality - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
<pas>
4
3.6.2.

+CFUN Set phone functionality

Description
Select the level of
functionality
Get current level
Get supported values
Parameters
<fun>
1 (default)
4
Omitted
<rst>
0 (default)
1
Clarification
AT+CFUN=1,1 has no effect on radio on/off, it leaves it as the same state it was before reset.
AT+CFUN=1,0 requests a radio on and memorize in non volatile memory <fun> level.
AT+CFUN=4,0 requests a radio off and memorize in non-volatile memory <fun> level.
At next switch on, ME will start with the <fun> level of the last +CFUN (i.e radio on or off). This allows
TE to have control on radio on/off.
+CFUN parameter is automatically saved into non-volatile memory.
The <fun> parameter is restored to default value by AT&F. Note that the module has to be restarted to
restore the default value. For example, if the current value of +CFUN=4 and AT&F is used to restore it
to default value, although +CFUN: 1 is displayed, the radio will not be turned ON until the module is
restarted.
WA_DEV_WISMO_UGD_012
Description
Call in progress (MT is ready for commands from TA/TE, but a call is in progress)
Command
+CFUN=[<fun>[,<rst>]]
+CFUN?
+CFUN=?
Description
Full functionality
Disable phone both transmit and receive RF circuits
Use previous value
Description
Do not reset the MT before setting it to <fun> power level
Reset the MT before setting it to <fun> power level
Rev 004
3GPP TS 27.007 Commands
Possible Response(s)
OK
+CME ERROR: <err>
+CFUN: <fun>
OK
+CME ERROR: <err>
+CFUN: (list of supported <fun>s), (list of
supported <rst>s)
OK
+CME ERROR: <err>
November 3, 2011 65