AT Command Manual for Firmware L23
address (given in the PDU) equals zero, the SMSC address set with command Service
Centre Address +CSCA is used; in this case the SMSC Type-of-Address octet shall not be
present in the PDU, i.e. TPDU starts right after SMSC length octet.
Sending can be cancelled by giving <ESC> character (IRA 27).
<ctrl-Z> (IRA 26) must be used to indicate the ending of the message body or PDU.
Text length is limited to PDU max length (164).
2.4.2.
+CMSS Send Message from Storage
Description
Send a message
from storage
Test if command is
supported
Parameters
<index>
1..255
In text mode <scts> is not supported, in PDU mode <ackpdu> is not supported.
For all other parameters, refer to 27.005 §3.1 Parameter Definitions.
Clarification
Since SMS-STATUS-REPORTs, SMS-COMMANDs and CBM are not stored in ME/TA memory, only
<index>s of SMS-SUBMITs and/or SMS-DELIVERs can be used in +CMSS.
2.4.3.
+CMGW Write Message to Memory
Description
Write a message
WA_DEV_WISMO_UGD_012
Command
+CMSS=<index>[,<da>[,<toda>]]
+CMSS=?
Description
Message location in "SM" memory.
Command
if text mode (+CMGF=1):
+CMGW[=<oa/da>[,<tooa/toda>[,<stat>]]]<CR>
text is entered<ctrl-Z/ESC>
if PDU mode (+CMGF=0):
+CMGW=<length>[,<stat>]<CR>PDU is given<ctrl-Z/ESC>
Rev 004
3GPP TS 27.005 Commands
Possible Response(s)
if text mode (+CMGF=1) and sending
successful:
+CMSS: <mr>[,<scst>]
OK
if PDU mode (+CMGF=0) and sending
successful:
+CMSS: <mr>[,<ackpdu>]
OK
if sending fails:
+CMS ERROR: <err>
OK
+CMS ERROR: <err>
Possible
Response(s)
+CMGW: <index>
OK
+CMS ERROR: <err>
November 3, 2011
26