AT Command Manual for Firmware L23
<dcs>
Integer type
Clarification
When TE sends an USSD to the network, the OK result code is sent before the response of the
network. When network answers, the response will be sent as an URC (as if it was a network initiated
operation, in case of error +CUSD: 4 will be sent).
This allows the link not to be blocked for a long time (the network can take a long time to answer a
USSD request initiated by the TE).
The USSD session can be aborted using command AT+CUSD=2.
3.4.15. +CAOC Advice of Charge
Description
Control AOC notification
Get current mode
Get supported values
Parameters
<mode>
0
1
2
<ccm>
String type
3.4.16. +CSSN Supplementary service notifications
Description
SS notification control
WA_DEV_WISMO_UGD_012
Description
Cell Broadcast Data Coding Scheme
Default value: 0
Command
+CAOC[=<mode>]
+CAOC?
+CAOC=?
Description
Query CCM value
Deactivate the unsolicited reporting of CCM value
Activate the unsolicited reporting of CCM value
Description
Three bytes of the current call meter value in hexadecimal format (e.g. "00001E"
indicates decimal value 30); value is in home units and bytes are similarly coded as
ACMmax value in the SIM card or in the active application in the UICC (GSM or USIM)
Command
+CSSN=[<n>[,<m>]]
Rev 004
3GPP TS 27.007 Commands
Possible Response(s)
If <mode>=0:
+CAOC: <ccm>
OK
+CME ERROR: <err>
+CAOC: <mode>
OK
+CME ERROR: <err>
+CAOC: (list of supported <mode>s)
OK
+CME ERROR: <err>
Possible Response(s)
OK
+CME ERROR: <err>
November 3, 2011
55