Cgpaddr Show Pdp Address - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
This command is used for PDP tests on network emulators. On real network functioning of +CGACT
and then +CGDATA for data transfer is not guaranteed.
+CGDATA implementation does not perform PS attach or PDP context activation. The PDP identified
by <cid>, when provided, in +CGDATA must have been activated previously thanks to +CGACT
command.
+CGDATA only switches channel to online data mode and open PPP server in a proprietary mode
For IP over PPP services, ATD*98 or ATD*99 commands must be used: when activating a PDP
context, PCO (protocol configuration option) has to be provided to network. PCO can be provided to
network only if a PPP negotiation (LCP/NCP negotiation) has been initiated between mobile and TE
before PDP activation (refer to TS 27.060 §9.1). This negotiation is possible only if AT channel is
switched to online data mode before PDP context activation. Hence, the PDP identified with <cid> in
+CGDATA should not have been activated by +CGACT  not possible in the current implementation
(+CGDATA does not behaves as ATD*9x when <cid> is not activated).
active (same behaviour has ATO command).
PDP test use case:
AT commands
AT+CGACT=1,1
OK
AT+CGDATA CONNECT
Data transfer
+++
OK
ATH
OK
AT+CGACT=0,1
OK

3.10.8. +CGPADDR Show PDP address

Description
Get PDP addresses
Get defined <cid>
WA_DEV_WISMO_UGD_012
as a relay).
Comments
PDP 1 is activated
No PCO negotiation
PPP server is opened in FTA mode, channel is switched in online data
mode
No LCP/NCP negotiation
Channel is back to online command mode
PPP server FTA mode is closed but PDP is NOT deactivated
PDP 1 is deactivated. (If ATH is not sent before deactivation, +CGACT
returns ERROR)
Command
+CGPADDR=[<cid> [,<cid>
[,...]]]
+CGPADDR=?
Rev 004
3GPP TS 27.007 Commands
o be sent on link in data mode.
Possible Response(s)
+CGPADDR: <cid>,<PDP_addr>
[<CR><LF>+CGPADDR: <cid>,<PDP_addr>
[...]]
OK
+CME ERROR: <err>
+CGPADDR: (list of defined <cid>s)
OK
+CME ERROR: <err>
November 3, 2011 93