Cmer Mobile Termination Event Reporting - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
<descr>
"battchg"
"signal"
"service"
"message"
"call"
"roam"
"smsfull"
Restriction
It is impossible to set indicators value.
3.6.8.

+CMER Mobile Termination event reporting

Description Command
Control URC
+CMER=[<mode>[,<keyp>[,<disp>[,<ind>[,<bfr>]]]]]
notifications
Get current
+CMER?
settings
Get supported
+CMER=?
values
Parameters
<mode>
0
1
Omitted
<keyp>
0
<disp>
0
WA_DEV_WISMO_UGD_012
Description
Battery charge level (0-5)
Signal quality (0-5)
Service availability (0-1)
Message received (0-1)
Call in progress (0-1)
Roaming indicator (0-1)
A short message memory storage in the MT has become full (1), or memory locations
are available (0)
Description
Buffer unsolicited result codes in the TA; if TA result code buffer is full, codes can be
buffered in some other place or the oldest ones can be discarded
Discard unsolicited result codes when TA TE link is reserved (e.g. in on line data
mode); otherwise forward them directly to the TE
Use previous value
Description
No keypad event reporting
Description
No display event reporting
Rev 004
3GPP TS 27.007 Commands
Possible Response(s)
OK
+CME ERROR: <err>
+CMER:
<mode>,<keyp>,<disp>,<ind>,<bfr>
OK
+CMER: (list of supported
<mode>s),(list of supported
<keyp>s),(list of supported
<disp>s),(list of supported <ind>s),(list
of supported <bfr>s)
OK
November 3, 2011 69