Cald Delete Alarm; Control And Status Result Codes; Ccwv Call Meter Warning Value - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
returned. To set up a recurrent alarm for one or more days in the week, the <recurr>-parameter may
be used.
When an alarm is timed out and executed, the unsolicited result code +CALV: <n> is always returned.
Read command returns the list of current active alarm settings in the MT. Test command returns the
supported syntax.

3.6.28. +CALD Delete alarm

Command
+CALD=<n>
+CALD=?
Parameters
<n>
1..5
Clarification
Action command deletes an alarm in the MT. If the command fails in an MT error, +CME ERROR:
<err> is returned. Test command returns supported index values.
3.7.

Control and Status Result Codes

3.7.1.

+CCWV Call Meter warning value

Description
Call meter warning value
Parameters
<ccm>
String type
Clarification
This warning will be triggered shortly before the ACM (Accumulated Call Meter) maximum value is
reached, an unsolicited result code +CCWV will be sent, if enabled by +CCWE command. The
warning is issued approximately when 30 seconds call time remains. It is also issued when starting a
call if less than 30 seconds call time remains.
WA_DEV_WISMO_UGD_012
Possible Response(s)
OK
+CME ERROR: <err>
+CALD: (list of supported <n>s)
OK+CME ERROR: <err>
Description
Integer type value indicating the index of the alarm
Result code
+CCWV
Description
Three bytes of the current call meter value in hexadecimal format (e.g. "00001E"
indicates decimal value 30); value is in home units and bytes are similarly coded as
ACMmax value in the SIM card or in the active application in the UICC (GSM or USIM)
Rev 004
3GPP TS 27.007 Commands
November 3, 2011 83