AT Command Manual for Firmware L23
8.6.21. +WMADC ADC Voltage Setting
Description
Write ADC voltage setting
Read current ADC voltage
setting
Test if command is supported
Description
This command allows for setting the range of ADC voltage to either 1V or 3V. The change will take
effect only after the module is rebooted.
Parameters
<range>:
<output>
Description
0 (default)
1V
1
3V
Example
Command
AT+WMADC=?
AT+WMADC=1
AT+WMADC?
Clarification
This command is available when the module has finished its initialization.
8.7.
Call and Network Proprietary Commands
8.7.1.
*PSCSCN Call state change notification
Description
Select notification presentation
mode
Get the current mode
WA_DEV_WISMO_UGD_012
Command
AT+WMADC=<range>
AT+WMADC?
AT+WMADC=?
Possible responses
+WMADC:(0,1)
OK
OK
+WMADC: 1
OK
Command
*PSCSCN=<mode>
*PSCSCN?
Rev 004
Proprietary AT Commands
Possible Response(s)
OK
+CME ERROR: <err>
+WMADC: <range>
OK
+WMADC: (list of supported <range>s)
OK
Possible Response(s)
OK
+CME ERROR: <err>
*PSCSCN: <mode>
OK
November 3, 2011
156