Cgact Pdp Context Activate Or Deactivate - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23

3.10.5. +CGACT PDP context activate or deactivate

Description
Activate or deactivate a PDP
Get current PDPs state
Get supported states
Parameters
<state>
0
1
<cid>
1..3
Clarification
This command is used to tests PDPs with network simulators.
network is not guaranteed, as it depends on whether the real network supports GPRS/EDGE service.
Refer to section 3.10.7 +CGDATA Enter data state for more information.
Examples:
To activate all defined contexts:
AT+CGACT=1
To deactivate all defined contexts:
AT+CGACT=0
To activate context 1:
AT+CGACT=,1
or
AT+CGACT=1,1
To activate context 2:
AT+CGACT=,2
or
AT=CGACT=1,2
Note: Entering AT+CGACT= (no specified parameters) returns OK without activating or deactivating the
PDP context.
WA_DEV_WISMO_UGD_012
Command
+CGACT=[<state>
[,<cid>[,<cid>[,...]]]]
+CGACT?
+CGACT=?
Description
Deactivated
Activated
Description
PDP Context Identifier
Rev 004
3GPP TS 27.007 Commands
Possible Response(s)
OK
+CME ERROR: <err>
+CGACT: <cid>,<state>
[<CR><LF>+CGACT: <cid>,<state>
[...]]
OK
+CME ERROR: <err>
+CGACT: (list of supported <state>s)
OK
+CME ERROR: <err>
Successful activation of PDP on real
November 3, 2011 91