Cgqreq Quality Of Service Profile (Requested) - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
<d_comp>
0
<h_comp>
0
Clarification
For <cid> 1,2 and 3, PDP context definition is stored in EEPROM i.e parameters provided in
+CGDCONT for PDP context definition and PDP context status (defined/undefined) are stored in non-
volatile memory (If a PDP has been defined with +CGDCONT, after a switch off / switch on,
AT+CGDCONT? will list the PDP has defined).
<cid> 3 is locked. This means that TE is not allowed to modify definition and parameters of <cid>=3
with +CGDCONT set command. This gives a default PDP context with parameters that TE cannot
change.
<cid> 3 is also the default <cid>: if +CGDCONT with <cid> omitted is received, <cid> 3 will be used.
+CGDCONT parameters are automatically saved into non-volatile memory.

3.10.2. +CGQREQ Quality of Service Profile (Requested)

Description
Set requested QOS (R97)
Get current settings
Get supported values
WA_DEV_WISMO_UGD_012
Description
PDP data compression off
Default if value is omitted
Description
PDP header compression off
Default if value is omitted
Command
+CGQREQ=[<cid>
[,<precedence>[,<delay>
[,<reliability>[,<peak>
[,<mean>]]]]]]
+CGQREQ?
+CGQREQ=?
Rev 004
3GPP TS 27.007 Commands
Possible Response(s)
OK
+CME ERROR: <err>
+CGQREQ: <cid>,<precedence >,<delay>,
<reliability>,<peak>,<mean>
[<CR><LF>+CGQREQ:
<cid>,<precedence>,<delay>,<reliability>,
<peak>, <mean>
[...]]
OK
+CME ERROR: <err>
+CGQREQ: <PDP_type>, (list of supported
<precedence>s),(list of supported <delay>s),
(list of supported <reliability>s) ,(list of
supported <peak>s),(list of supported
<mean>s)
[<CR><LF>+CGQREQ: <PDP_type>,(list of
supported <precedence>s),(list of supported
<delay>s),(list of supported <reliability>s), (list
of supported <peak>s),(list of supported
<mean>s)
[...]]
OK
+CME ERROR: <err>
November 3, 2011 88