AT Command Manual for Firmware L23
4.3.3.
S3 Line termination character
Description
Set line termination character
Get current value
Parameters
<char>
13 (default)
Clarification
S3 parameter is saved into non-volatile memory by AT&W command and restored to default value by
AT&F command.
4.3.4.
S4 Response formatting character
Description
Set response formatting
character
Get current value
Parameters
<char>
10 (default)
Clarification
S4 parameter is saved into non-volatile memory by AT&W command and restored to default value by
AT&F command.
4.3.5.
S5 Line editing character
Description
Set line editing character
Get current value
WA_DEV_WISMO_UGD_012
Command
S3=<char>
S3?
Description
Termination character <CR>
Command
S4=<char>
S4?
Description
Termination character <LF>
Command
S5=<char>
S5?
Rev 004
ITU-T V25.ter Commands
Possible Response(s)
OK
ERROR
<char>
OK
Possible Response(s)
OK
ERROR
<char>
OK
Possible Response(s)
OK
ERROR
<char>
OK
November 3, 2011
110