Ping - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
AT+WIPDATA=1,1,1
CONNECT
...
+++
OK
AT+WIPCLOSE=1,1
OK
AT+WIPCREATE=1,1,1234
OK
+WIPREADY: 1,1
+WIPDATA: 1,1,25,"192.168.0.2",2397
AT+WIPDATA=1,1,1
CONNECT
abcedghijklmnopqrstuvwxyz[ETX]
OK
+WIPDATA: 1,1,50,"192.168.0.4",58
AT+WIPDATA=1,1,1
CONNECT
abcedghijklmnopqrstuvwxyzabcedghijklm
nopqrstuvwxyz [ETX]
9.7.4.

PING

AT+WIPCFG=1
OK
AT+WIPBR=1,6
OK
AT+WIPBR=2,6,11,"APN name"
OK
WA_DEV_WISMO_UGD_012
//exchange data on socket idx 1:
//read, write
//switch to AT mode
//close the UDP socket index 1
//start a UDP server and listen for datagram on port 1234
//all parameters and IP stack //behavior are OK
//unsolicited: the UDP client socket is "pseudo" connected
//to the peer (no real connection is UDP)
//one datagram is ready to be read : it was sent from
//192.168.0.2 on port 2397 and is composed of 25 bytes
//here 25 bytes + the [ETX] character (marking the bound
//of the datagram) have been read.
//here UART is back to AT command mode. If some other
//remote IP devices sent one or more datagrams while
//reading for the first one, then a new datagram indication
//is received
//one datagram is ready to be read : it was sent from
//192.168.0.4 on port 58 and is composed of 50 bytes
//here 25 bytes + the [ETX] character (marking the bound
//of the datagram) have been read.
Rev 004
//start IP stack
//open GPRS bearer
//set APN name of GPRS bearer
November 3, 2011
TCP/IP Commands
205