Chup Hang-Up Call; Cbst Select Bearer Service Type - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
Description
Get current type
Get supported types
Parameters
<mode>
0
Clarification
This command has no effect. It is for compatibility only.
3.2.3.

+CHUP Hang-up call

Description
Hang up calls
Test if command is supported
Clarification
+CHUP command gives an assured procedure to disconnect the call.
Refer to section 4.1.4 H Hang up.
Since only single mode is supported, the execution of the command always disconnects active call.
3.2.4.

+CBST Select bearer service type

Description
Select bearer
Get current bearer
Get supported types
Parameters
<speed>
0
7 (default value)
WA_DEV_WISMO_UGD_012
Command
+CMOD?
+CMOD=?
Description
Single mode
Command
+CHUP
+CHUP=?
Command
+CBST=[<speed>[,<name>[,<ce>]]]
+CBST?
+CBST=?
Description
Autobauding (automatic selection of the speed; this setting is possible in case of 3.1
kHz modem and non-transparent service)
9600 bps (V.32)
Rev 004
3GPP TS 27.007 Commands
Possible Response(s)
+CMOD: <mode>
OK
+CMOD: (list of supported <mode>s)
OK
Possible Response(s)
OK
+CME ERROR: <err>
OK
+CME ERROR: <err>
Possible Response(s)
OK
+CME ERROR: <err>
+CBST: <speed>,<name>,<ce>
OK
+CBST: (list of supported
<speed>s),(list of supported
<name>s),(list of supported <ce>s)
November 3, 2011 36