AT Command Manual for Firmware L23
3.2.10. +CSNS Single Numbering Scheme
Description
Select the bearer to be used when an MT
single numbering scheme call is set up.
Get current mode
Get supported modes
Parameters
<mode>
Bearer to be used
0
Voice
2
Fax
4
Data
Example
Command
AT+CSNS=0
Note: Force a voice call
AT+CSNS?
Note: Get current value
AT+CSNS=?
Note: Test command
Clarification
This command selects the bearer to be used when an MT single numbering scheme call is set up.
Once the action command executed and returned OK, the new value will be stored in EEPROM.
This command is available when the module has finished its initialization.
3.3.
Call Control Result Code
3.3.1.
+CR Service reporting
Description
+CR notification sent during data call
connection
WA_DEV_WISMO_UGD_012
Command
AT+CSNS=<mode>
AT+CSNS?
+CSNS=?
Possible responses
OK
+CSNS: 0
OK
+CSNS: (0,2,4)
OK
Result code
+CR: <serv>
Rev 004
3GPP TS 27.007 Commands
Possible Response(s)
OK
+CSNS: <mode>
OK
+CSNS: (list of supported <mode>s)
OK
November 3, 2011
41