Error Codes - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
AT+WIPBR=4,6,0
OK
AT+WIPCREATE=3,2,80,1,2
OK
AT+WIPCREATE=2,3,"198.168.0.1",80
OK
+WIPREADY: 2,3
+WIPACCEPT: 2,1
AT+WIPDATA=2,3,1
CONNECT
abc+++
OK
AT+WIPDATA=2,1,1
CONNECT
9.8.

Error Codes

"+CMEE" AT Error Code
3
800
801
802
803
804
805
806
807
808
809
810
811
812
813
814
815
WA_DEV_WISMO_UGD_012
Description
operation not allowed
invalid option
invalid option value
not enough memory
operation not allowed in the current TCP/IP stack state
device already open
network interface not available
operation not allowed on the considered bearer
bearer connection failure : line busy
bearer connection failure : no answer
bearer connection failure : no carrier
bearer connection failure : no sim card present
bearer connection failure : sim not ready (no pin code entered, ...)
bearer connection failure : GPRS network failure
bearer connection failure : PPP LCP negotiation failed
bearer connection failure : PPP authentication failed
bearer connection failure : PPP IPCP negotiation failed
Rev 004
//start GPRS bearer
//create the server on port 80, idx=2. The server is
//listening for connection requests on port 80.
//Spawned sockets will be given the index 1 or 2. It
//will accept connection request until it has nor more
//sockets left.
//create a TCP client towards peer IP device @
//"198.168.0.1", port 80,
//all parameters and IP stack behavior are OK.
//unsolicited: the TCP client socket is connected to the
//peer.
//unsolicited: the server index accepted a connection;
//resulting TCP client on idx 1
//exchange data on socket index 3
//data sent to socket index 1 and switched to AT
//mode by giving +++
//exchange data on socket index 1
November 3, 2011
TCP/IP Commands
213