Pssrep Mobile Start-Up Reporting - Sierra Wireless AirPrime WS Series At Command Manual

AT Command Manual for Firmware L23
Description
Service ready
Parameters
<mode>
0
1
<service>
0
1
2
Clarification
If a service becomes available before any AT channel is connected, *PSREADY notification will be
buffered and sent as soon as the first AT channel connects.
8.6.3.

+PSSREP Mobile start-up reporting

Description
Set mode
Get current mode
Get supported modes
Parameters
<act>
0 or 1
<stat>
0 or 1
WA_DEV_WISMO_UGD_012
Result code
*PSREADY: <service>
Description
Disable notification presentation
Enable notification presentation
Description
Phone book service availability
SMS service availability
CBM service availability
Command
+PSSREP=<act>
+PSSREP?
+PSSREP=?
Description
Indicates if the module must send an unsolicited code during the startup.
0: The module doesn‟t send an unsolicited code (default value)
1: The module will send an unsolicited code +PSSUP
Description
This code indicates the status of the module.
0: The module is ready to receive commands for the TE. No access code is
required
1: The module is waiting for an access code. (The AT+CPIN? command can be
used to determine it)
2: The SIM card is not present
3: The module is in "SIMlock" state
4: unrecoverable error
5: unknown state
Rev 004
Possible Response(s)
OK
+CME ERROR: <err>
+PSSREP: <act>,<stat>
OK
+PSSREP: (list of supported <act>s)
OK
November 3, 2011
Proprietary AT Commands
142