AT Command Manual for Firmware L23
Description
Get current settings
Get supported values
Parameters
Refer to section 3.10.2 +CGQREQ Quality of Service Profile (Requested).
Clarification
Refer to § 6.1.2 for QoS mapping between R99 and R97/R98 QoS.
3.10.4. +CGATT PS attach or detach
Description
Attach or detach
Get current state
Get supported states
Parameters
<state>
0 (default)
1
WA_DEV_WISMO_UGD_012
Command
+CGQMIN?
+CGQMIN=?
Command
+CGATT=[<state>]
+CGATT?
+CGATT=?
Description
Detached
Attached
Rev 004
3GPP TS 27.007 Commands
Possible Response(s)
+CGQMIN: <cid>,<precedence>,<delay>,
<reliability>,<peak>,<mean>
[<CR><LF>+CGQMIN: <cid>,<precedence>,
<delay>,<reliability>,<peak>,<mean>
[...]]
OK
+CME ERROR: <err>
+CGQMIN: <PDP_type>, (list of supported
<precedence>s),(list of supported <delay>s),
(list of supported <reliability>s),(list of
supported <peak>s),(list of supported
<mean>s)
[<CR><LF>+CGQMIN: <PDP_type>, (list of
supported <precedence>s),(list of supported
<delay>s),(list of supported <reliability>s), (list
of supported <peak>s),(list of supported
<mean>s)
[...]]
OK
+CME ERROR: <err>
Possible Response(s)
OK
+CME ERROR: <err>
+CGATT: <state>
OK
+CME ERROR: <err>
+CGATT: (list of supported <state>s)
OK
+CME ERROR: <err>
November 3, 2011
90