AT Command Manual for Firmware L23
Description
Read command reads the AHPLMN (Active Home PLMN).
Parameters
<MCC>
Integer type
<MNC>
Integer type
8.6.9.
+PSTAT Tool Detection Enable
Description
Trig restart with tool detection
Parameters
<param>
Integer type
Clarification
The set command enables the tool presence detection by the module and provokes an intended
watchdog reset.
When restarting after the watchdog reset, the module
Further reboots (intended or not) does not provoke tool detection procedure.
This AT command is only for TAT to reset the module so no OK response is needed. After
successfully sending the command, no OK response is given and the module will reset immediately.
8.6.10. *PSRDBS Radio band settings
Description
Set radio bands
Get current values
Get supported values
Description
Set command is used to set the radio band(s).
When <mode>=0, band settings are taken into account only at next switch on. However, the read
command will display the band settings to be applied after next switch on.
WA_DEV_WISMO_UGD_012
Description
Mobile country code in numeric format (e.g. "208")
Description
Mobile network code in numeric format (e.g. "10")
Command
+PSTAT=<param>
Description
Useless parameter (any 2-digit number)
Command
*PSRDBS=<mode>,<GSM band>
*PSRDBS?
*PSRDBS=?
Rev 004
Proprietary AT Commands
Possible Response(s)
+CME ERROR: <err>
Possible Response(s)
OK
+CME ERROR: <err>
*PSRDBS: <GSM band>
OK
*PSRDBS: (list of supported <mode>s),(list of
supported <GSM band>s)
OK
November 3, 2011
147